When you have downloaded it, you must configure it - this is
a fairly straightforward process and is described briefly
below. After installation and on running the program it will
display the following screen.
This should be partially covered by the following.
In which case press
Add. If the screen above does not come up then Right click
the phones screen which will display.
Pressing
SIP account options will get you the SIP Accounts screen
above.
Pressing
Add or if there is one already there Properties will show
the following screen
.
Enter your
name as you wish it to be seen as the CallerID for those
people you call under display name. Your extension in
Username and also in Authorization user name, Your password
in password.
In domain please enter sip.xxxxxxxxxx.net or if instructed
to by email lon-pbx-N.xxxxxxxxxx.net. [Where N can be any
number from 1 to 7.]
Click on the proxy tab and enter nat.xxxxxxxxx.net:5082 [or
nat1 or nat2 as indicated in any email sent to you] Then
click on the Topology tab at the top.
and select
Use local IP address at the top. Click apply on the bottom
right hand corner and we would expect it to immediately
work.
Dial 160
to try the echo test. You should hear everything you say
echoed back to you.
Note:
If after configuring the software you get one way audio
problems these can be resolved by changing the following
settings:
Options... Advanced... Audio Codecs and removing all but one
(e.g., G711 uLaw) from the list of enabled codecs
Dial ***7469 (SEND)
Filter for Honor: Change the value of Honor first codec to 1
save and restart the application. [by closing and saving
when asked]
A note on Dialing plans:
to allow your xlite to use +44 as a prefix for the number
you will need a dialing plan that strips the + sign and
replace it with 00.
